Open type:23 0941 01
di:834mm
Da:1048mm
H:56mm
Li:862mm
La:1020mm
m:-mm
z:-mm
VLU200944
Rolling Elements | Ball |
Space retainer | Yes |
Material | GCr15 Bearing steel / 50Mn |
Standard lubrication method | Grease lubrication |
Lubrication hole | Yes |
Sealing | NBR sealing at both sides |
Raceway Hardness | HRC 55 ~ 60 |
Working temperature | -20℃ ~ 40℃ |
Check more Rollix light series slewing bearing models.
1. Provide an exceptional moment, thrust, and radial load capacities.
2. Normal clearance, suitable for light to medium-duty arrangements which require lower accuracy.
3. Easy installation, with mounting holes on the inner and outer ring.
4. Lightweight and thin section.
1. Make sure the mounting surface is flat and clean and free from burrs or
rough edge.
2. The unhardened zone is marked with an “S” on the slewing ring, it must be positioned outside the main load-carrying areas.
3. Commissioning of the slewing ring under sufficient load.
4. Adjust the backlash of gear and recheck it after the final tightening of the bearing.
5. Fastening bolts. Place the bearing onto the connecting structure and align the screw holes. Screw all the bolts in the holes first and follow the order as shown in the diagram when tightening bolts in the diagonally opposite sequence. Do not tighten bolts randomly.
6. Check the installation by rotating the assembled bearing arrangement. The torque should not show any excessive variation or “tight spots” during rotation.
We will reply to your message within 24 hours