• RA16013 cross roller bearing
  • THK RA16013 bearing
  • RA16013 slewing ring bearing structure
  • Part NO.

    Open type:RA16013

  • Dimension




  • Mounting

  • Basic Load Ratings



  • Equivalent Model


  • Features
  • Mounting
  • RA16013 cross roller bearing specifications:

    Type of guide Roller
    Space retainer Yes
    Material GCr15
    Standard lubrication method Grease lubrication
    Oil hole Yes
    Sealing Oil seal at both sides
    Radial clearance CC0, C0
    Rotation accuracy Radial/axial runout below 25μm
    Working temperature -20℃ ~ 80℃

    * RA16013UU is two sides sealed type.

    More RA cross roller bearing models


    RA16013 crossed roller bearing features:

    1. Integrated inner ring with separable outer ring.

    2. Sustain radial, axial and moment loads at the same time.

    3. High rigidity & running accuracy.

    4. Ultra-thin section, space saving and reduce the overall weight of the device.



    1. I’m designing a prototype, can you produce according to my design?
    Yes, BRS can produce custom design based on users requirements, but there will be a MOQ.


    2. Why the preload type RA cross roller bearings are widely selected?

    Because RA16013UU bearing with preload (clearance -0.01~0 mm) can improve bearings rotation accuracy, increase stiffness, improve the bearing’s damping and reduce noise. Check “Prelaod of crossed roller bearings” for more detailed info.


    2. How to lubricate RA series crossed roller bearings?
    Unless otherwise stated, all BRS made RA cross roller bearings are filled with proper amount of complex lithium grease before delivery. So users can directly put bearings into application after receiving goods. Then after 1~6 months operation, bearings should be added with proper grease through grease holes on the outer ring based on working conditions.

  • RA16013 cross roller bearing installation instructions

    Cautions: For crossed roller bearings with split outer ring, when the rigidity of the mounting parts is not sufficient, stress concentration will occur at the contact area between the rollers and raceways, and the bearing performance will be deteriorated significantly.

    Therefore, it is necessary to carefully examine the rigidity of housing and the strength of fixing bolts when a large moment will be applied.


    1. Before installation, please clean bearing bracket, shaft, or other components, make sure there is no burrs or rough edge.
    2. Fix the inner and outer rings in the axial direction by using fixing plates, etc.
    3. Slightly loosen the fixing bolts of bearings outer ring during mounting.


We will reply to your message within 24 hours