RKS.160.14.0414 crossed roller slew bearing specifications:

Other RKS.160 crossed roller slewing bearing models

Equivalent slewing bearing model (four point contact ball slewing bearing structure): RKS.060.20.0414

RKS.160.14.0414 slewing bearing features:

1. Support combined loads from radial and axial, as well as moment loads.

2. High stiffness structure, provide high load capacity and resistant to shock loads.

3. Easy installation, with mounting holes on both inner and outer ring.

4. Pre-load arrangements with zero operational clearance, provide high rotation accuracy.

5. Customized size and structure available.

RKS.160.14.0414 crossed roller bearing installation instructions

Mounting Size

Inner ring mounting holes: Ji 368mm, 24-φ14mm through

Outer ring mounting holes: Je 460mm, 24-φ14mm through

1. Make sure the mounting surface is flat and clean, and free from burrs or

rough edge.

2. The unhardened zone is marked with an “S” on the slewing ring, it must be positioned outside the main load-carrying areas.

3. Commissioning of the slewing ring under sufficient load.

4. Adjust the backlash of gear and recheck it after final tightening of the bearing.

5. Fastening bolts. Place the bearing onto connecting structure and align the screw holes. Screw all the bolts in the holes first and follow the order as shown in diagram when tightening bolts in diagonally opposite sequence. Do not tighten bolts randomly.

6. Check the installation by rotating the assembled bearing arrangement. The torque should not show any excessive variation or “tight spots” during rotation.